English-55
PowerSaver
This set has a built-in power management system called PowerSaver. This system saves energy by
switching your set into a low-power mode when it has not been used for a certain period of time.
The available modes are “On”, “Standby”, “Sleep”, and “Deep Sleep”. PowerSaver operates with a VESA
DPMS compliant video card installed in your computer. You use a software utility installed on your
computer to set up this feature.
State Normal Operation Power-Saving Function mode
(EPA/NUTEK)
Horizontal Sync Active Inactive
Vertical Sync Active Inactive
Power Indicator Green Green, Blinking (1 sec interval)
Power Consumption 52 W (Normal) Less than 3 W
➣This set automatically returns to normal operation when horizontal and vertical sync
are restored.
This occurs when you move the computer’s mouse or press a key on the keyboard.
Troubleshooting: Before Contacting Service Personnel
In PC mode, the image is not stable and
may appear to vibrate.
In PC mode, the image is not centred on
the screen.
◆Check that the display resolution and frequency from your
computer or video board is an available mode for your set.
On your computer check: Control Panel, Display, Settings.
◆If the setting is not correct, use your computer utility programme to
change the display settings.
◆Adjust the horizontal and vertical position.
Your set supports multiscan display functions within the
following frequency domain:
Horizontal frequency - 30 ~ 68 kHz
Vertical frequency - 56 ~ 85 Hz
Maximum refresh rate - 1280 x 768 @ 60Hz
04-BN68-00437D-01Eng 9/24/03 4:01 AM Page 55