![](/images/new-backgrounds/1313364/313364127x1.webp)
Setting Up Your Remote Control
Setting Up the Remote to Operate Your Cable Box
1Turn off your cable box.
2Press the SELECT button and make sure that the Cable LED is illuminated.
3Press the SET button on your TV’s remote control.
4Using the number buttons on your remote control, enter three digits of the cable box code listed on page 65 of this manual for your brand of cable box. Make sure you enter three digits of the code, even if the first digit is a “0”.
If there is more than one code listed, try the first one.
5Press the Power button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3, and 4, but try one of the other codes listed for your brand of cable box. If no other codes are listed, try each code, 000 through 077.
Note on Using Remote Control Modes: Cable Box
When your remote control is in “Cable Box” mode, the volume buttons still control your TV’s volume.