Raymarine Raychart Chartplotter RC530 PLUS, RL80CRC PLUS Radar Set Up Parameters, EBL Display

Chapter 7: Setting Up the System Defaults 7-11

7.4 Radar Set Up Parameters

The RADAR SET UP option allows you to set up the radar according to your system configuration and your personal preferences.

Note: Some parameters can only be changed if you are using the Master dis- play (that is, the display to which the scanner is connected).

The following table lists the Radar Set Up parameters and their options, shows the factory default setting, and provides a space for you to make a note of your new default setting. Each parameter is described in the fol- lowing subsections.

Table 7-2:	Radar Set Up Parameters
Parameter		Options			Factory Default	New Default
EBL DISPLAY		MAG/TRUE, RELATIVE			RELATIVE
TIMED		OFF, ON			OFF
TRANSMIT
TRANSMIT PERIOD		10 scans, 20 scans, 30 scans			20 scans
STANDBY PERIOD		3, 5, 10 or 15 mins			10 minutes
							SetRadarUp Parameters
DEFAULT MARK
SYMBOL		,	,	,
MARK DISPLAY		OFF, ON			ON
CLEAR MARKS		Press soft key to clear marks			N/A
		database
CUSTOM SCALE		OFF, ON,SET RANGES...			OFF
BEARING		Slider value			0°
ALIGNMENT
ANTENNA SIZE		4 ft., 6ft (only if an open array			4 ft.
		scanner is connected)
SEND ON HSB		ON, OFF			ON

EBL Display

The mode of the bearing data displayed for Electronic Bearing Lines (EBLs). The bearing information can be displayed in either of two forms:

•Relative: The bearing relative to your vessel’s heading.

•Mag/True: The actual bearing in either degrees magnetic or degrees true. This option is only available if you are obtaining data from a compass.

If you choose this mode, the selection you made for Bearing Mode determines whether °M or °T is displayed in the EBL data boxes. The current units are shown for the heading value in the status bar at the top of the screen.