Raymarine Chartplotter RL70CRC PLUS, RL80CRC PLUS manual Using Marks, Placing a Mark

Using Marks

4-4 hsb2 PLUS Series Color LCD Display

4.3 Using Marks

The Marks function allows you to place a mark anywhere on the radar picture. You can also move existing marks or delete them. You should be aware that radar marks are not the same as chart waypoints and cannot be used in routes, nor can they be transferred to other displays.

Marks are placed with the default mark symbol at either cursor or vessel position. If you wish to use a different symbol, you can change the default setting from the RADAR SET UP menu (see Section 7.4). Mark symbols are always displayed within a circle.

Marks are stored with their latitude, longitude and symbol; the information is retained when the radar is turned off. Up to 100 marks can be stored in each display unit.

Note: When you use the MARKS key to access the Marks function, simply

MARKS

press the key momentarily and release it. If you hold it down for two seconds, the Pathfinder Radar will enter man overboard (MOB) mode, as described in Section 4.4.

The Marks function is only available when your vessel’s position is known via the SeaTalk or NMEA connection.

Placing a Mark

MARKS

PLACE MRK AT CURSOR

➤To place a mark symbol:

1.Press the MARKS key. The soft keys PLACE MRK AT CURSOR and PLACE MRK AT VESSEL are displayed.

2.To place a mark at the cursor, position the cursor at the required point. If you are displaying the cursor position box showing the lat/long position, you can check the coordinates to place the mark accurately.

Press the PLACE MARK AT CURSOR softkey.The mark is placed using the default symbol.

PLACE MRK	3. To place a mark at the vessel position, press PLACE MRK AT VESSEL. The
AT VESSEL
	mark is placed using the default symbol.

Note: If the Mark database is full, a warning message is displayed, with the position (in latitude and longitude) of the oldest mark. You have the following options:

i.Press the YES soft key to replace this old mark with the new mark.

ii.Press the NO soft key to keep the old mark and display the next oldest mark. You can keep pressing NO to step through the mark database until a mark you wish to replace is displayed, and then press YES.

iii.Press CLEAR to keep all the existing marks, and cancel the new mark placement.