Raymarine Raychart Chartplotter RC530 PLUS manual Resetting the System, Power On Default Settings

Chapter 9: Maintenance and Problem Solving 9-3

9.2 Resetting the System

There are three types of reset available for the display:

• Factory Reset: This resets all values back to their original factory settings.

CAUTION:

The factory reset clears the Marks database, and the chartplotter

Waypoints and Routes databases.

•Power-On Reset: When you turn the display off and on again, the screen reverts to the fishfinder or chart picture with all windows cleared.

•Picture Reset: Press and hold the DISPLAY key for two seconds to return the screen to the full-screen picture of the top window with all windows cleared.

At power-on, the last-used values are retained for all the options, except for those listed in the following table which are reset to the factory default each time.

Table 9-1: Power On Default Settings

Item	Power-on setting
Heading Mode	Head Up (radar); North Up (chart)
Rain	OFF (but value stored) – radar only
FTC	OFF (but value stored) – radar only
Alarm	ON, with last-used value
Zoom	OFF
Windows	OFF
Brightness	ON at 100%.

➤To perform a factory reset:

1.Press MENU.

2.Press the SYSTEM SET UP soft key to display the System Set Up page (see Section 7.3 for details).

3.Press and hold MENU for 5 seconds.

A countdown timer is displayed. If you release the MENU key before the timer reaches zero, the reset is not performed.

When the reset request has been accepted, the system restarts.

The factory default settings are listed in Section 7.3

Resetting the System