Raymarine Raychart Chartplotter RC530 PLUS, RL80CRC PLUS Changing the Targets Display, Status Bar

Chapter 3: Standard Radar Operations 3-11

Changing the Targets Display

The Pathfinder Plus Radar allows you to improve target visibility by changing the following:

•Interference rejection

•Target expansion

•Target wakes

These parameters are accessed from the default soft key TARGETS.

This section explains how to change these modes and describes the effect of each mode. The current settings are shown at the right-hand end of the status bar as shown in Figure 3-9.

Status Bar				Wakes on		Target Expansion on
	3nm	RINGS	126°T	TM TV3	AUTO WKS EX GZ
		1/2		H-UP	GST	FTC RC IR

Interference Rejection on

D3986-2

Figure 3-9: Status Bar

➤To change the settings of the target modes:

1.Press the TARGETS default soft key.

The target option soft keys are displayed, with the current selections high- lighted.

Changing the Targets Display

TARGETS

WAKES

OFF S M L

INT REJ		EXPANSION			WAKES		CLEAR
OFF				ON		S M L	WAKES
	ON		OFF		OFF

D3642-2

2.Press the appropriate soft key to toggle the required setting between OFF and ON.

Note: If an option is not available for the current setting, its soft key label is grey. When you press the key, the system beeps and the setting remains OFF.

For the Wakes mode, press the WAKES soft key to step the highlighted selection through the wake options.

You can use the soft keys to change the settings of any or all the modes on this display.

3.When the required options are highlighted, press ENTER. The screen returns to the default display with the new mode(s) in operation. The status bar is updated to indicate which controls are switched on.