Playing a Disc, Video Output Selection

Loading and Changing Compact Discs

The CD disc changer can contain up to three 12 cm or 8 cm compact discs without using an adapter.

Never force the compact disc carrousel when opening and clos- ing the compartment.

Never press down or place objects on the carrousel.

Always treat your compact discs with care; refer, if necessary, to the section entitled “Precautions When Using Compact Discs” on page 41.

1 Switch the system on by pressing On/Standby.

2 Press the Open/Close( ) button on the front panel. Result: The compartment opens.

3 Place one or two discs in the front slots of the carrousel, with the label on the discs facing upwards.

Check that the compact disc has been correctly inserted in the holder before closing the compartment.

4 If you wish to load a third compact disc, press the Disc Change but- ton on the front panel (or Disc Skip on the remote control).

Result: The carrousel rotates by 120°.

5 Close the compartment by pressing the Open/Close( ) button again.

If you wish to start playing a disc directly, you can also proceed as follows.

Result: The compartment closes automatically and the disc selected starts playing.

6 To change or unload the compact disc changer, repeat Steps 2 to 5.

Keep the compartment closed whenever you are not using it, to prevent dust from entering.

You can load or unload compact discs when the radio, tape or auxiliary source function is selected.

1 Press the Open/Close( ) button.

2 Place a disc gently into the tray with the disc's label facing up.

3 Press the Play/Pause button or Open/Close( ) button to close the disc tray.

1,3

DVD/CD

Press the Dolby Surround button in POWER OFF, then it is converted to

“	NTSC	PAL	SECAM	” and select the TYPE you want.
“				” and select the TYPE you want.

When disk is set to NTSC in PAL, it doesn't operate.