Serial ATA cable

To install a Serial ATA hard disk drive:

1.Follow steps 1-3 of the previous section.

2.Connect one end of the supplied 7-pin SATA cable to the

connector at the back of the drive, then connect the other end

to the SATA connector on the motherboard. See page 4-7 for the location of the Serial ATA connector.

3.For Serial ATA HDDs with a 4-pin power connector:

Connect a 4-pin (female) power plug from the power supply unit (PSU) to the 4-pin (male) power connector at the back of the drive.

For Serial ATA HDDs without a 4-pin power connector:

Use the supplied SATA power cable. Connect a 4-pin plug (female) from the PSU to the

4-pin (male) plug of the SATA power cable. Connect the

15-pin SATA power plug to the power connector at the back of the drive.

15-pin

4-pin (male)

Serial ATA power cable

ASUS Pundit P1-PH1 system

2-17