5.3.3Primary IDE Master/Slave; First SATA Master

IDE Primary Master

Select Menu

 

 

Item Specific Help

Primary IDE Master

[Auto]

Press [Enter] to

Access Mode

[Auto]

select.

Capacity

XX MB

 

Cylinder

XXXXX

 

Head

XX

 

Sector

XXX

 

PIO Mode

[Auto]

 

UDMA Mode

[Auto]

 

Transfer Mode

UDMA5

 

Primary IDE Master [Auto]

Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is successful, Setup automatically fills in the correct values for the remaining fields on this sub-menu. If automatic detection fails, this may be because the hard disk drive is too old or too new. If the hard disk was already formatted on an older system, Setup may detect incorrect parameters. In these cases, select [Manual] to manually enter the IDE hard disk drive parameters. Refer to the next section for details. Configuration options: [None] [Auto] [Manual]

Before attempting to configure a hard disk drive, make sure you have the correct configuration information supplied by the drive manufacturer. Incorrect settings may cause the system to fail to recognize the installed hard disk.

Access Mode [Auto]

This item allows the user to select the sector addressing mode. Configuration options: [CHS] [LBA] [Large] [Auto]

PIO Mode [Auto]

This option lets you set a PIO (Programmed Input/Output) mode for the IDE device. Modes 0 through 4 provide successive increase in performance. Configuration options: [Auto] [Mode 0] [Mode 1] [Mode 2] [Mode 3] [Mode 4]

ASUS Pundit P1-PH1 system

5-11