setting uP tHe ReFRigeRAtoR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual. (P8. Selecting the best location for the Refrigerator)
2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessories listed below.
PU ESTTING01
Compression fitting | Compression nut |
Required Tools (Not provided)
Phillips Head Driver(+) | Flat Head | Socket Wrench | Hex Wrench (3/16inch) | Hex wrench (5/32 inch) |
|
| (10mm) (for bolts) | (for Mid hinge) | (for Mid hinge shaft) |
Removing the refrigerator doors
Some installations require door/drawer removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read following items.
WARNING Disconnect power to the Refrigerator before remove door or drawer.
•Be careful not to drop the door and door scratch and damage while removing the door/drawer.
•Be careful not to get injured while removing the door/drawer.
•After reattaching the door/drawer:
It is possible to have sweat by air leakage.
It is possible to have uneven door alignment. It is possible to have more energy bills.
Setting Up _13
