Spacer
Spacer
•Remove paper on spacer and then attach a spacer (Gray block) on the
back side of refrigerator for better performance. Make sure a spacer fix like above image when you install the refrigerator. It is improving the refrigerator performance.
(Only for RB31F***B, RB29F***B model)
•Allow sufficient space to the right, left, back and top for air circulation.
This will help reduce power consumption and keep your energy bills lower.
•Do not install the refrigerator where the temperature will go below 10 °C.
•Please ensure that appliance can be moved freely in the event of maintenance & service.
When installing, servicing, or cleaning CAUTION behind the refrigerator, be sure to pull the
unit straight out and push back in straight after finishing.
Also, make sure your floor supports the
Otherwise, it may cause floor damage.
Please tie up the extra length of the power CAUTION cord at the back of the refrigerator so as
not to be touched on the floor preventing the power cord from being crushed by the rollers upon relocation.
FLOORING
For proper installation, this refrigerator must be |
|
|
placed on a level surface of hard material that has |
|
|
the same height as the rest of the flooring. This |
|
|
surface should be strong enough to support a fully | up |
|
loaded refrigerator (or approximately 65 kg). To |
| |
|
| |
protect the floor finish, cut a large section of the |
|
|
cardboard carton and place it under the refrigerator |
|
|
where you are working. | 01setting |
|
• Pulling or pushing the refrigerator may |
| |
|
| |
damage the floor. |
|
|
Moving the refrigerator after installation |
|
|
|
| |
may damage the floor. |
|
|
LEVELLING THE REFRIGERATOR
If the front of the appliance is slightly higher than the rear, the door can be opened and closed more easily.
Case 1) The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the arrow until the appliance is level.
< Case2 >
< Case1 >
setting up _17
