Samsung RF220NCTASP/ML manual Accessories and Required Tools, Removing the Refrigerator Doors

FLOORING

For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the fl oor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 150 kg.

To protect the fi nish of the fl ooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.

ACCESSORIES AND REQUIRED TOOLS

The following accessories are included with your refrigerator:

REMOVING THE REFRIGERATOR DOORS

For some installations you need to remove the fridge and freezer drawers so you can move the refrigerator to its fi nal location. Do not remove the doors/drawer if you don’t need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 15. If you need to remove the doors. continue below.

Before removing the door/drawer, make sure you read the following items:

Disconnect power to the refrigerator before WARNINGremoving the door or drawer.

• Be careful not to drop, damage or scratch the door/drawer while removing them.

•Be careful not to get injured while removing the door/drawer.

•Reattach the door/drawer properly to avoid:

-Moisture from air leakage. -Uneven door alignment.

-Wasting energy due to improper door seal.

Disassembling the fridge door

Be careful not to drop and scratch the WARNINGdoors while removing the doors.

1.Remove the 3 screws holding down the top table and remove it.

Hex wrench

Top Table

Required Tools (Not provided)

You need the following tools to complete the installation of your refrigerator:

Philips	Flat-blade screw	Socket wrench
screwdriver(+)	driver(-)	(10 mm)
Pliers	Allen wrench
	(5 mm)

2.Disconnect electric wire on the top of the refrigerator.

18_ setting up

DA68-02787D.indb 18 2013.3.6 7:57:8 PM