Samsung RF263AFBP Setting up your French Door Refrigerator, Reverse Osmosis Water Supply

Setting up your French Door Refrigerator

4 Cover filter. 5

4. Remove the filter cap and insert the filter into the filter housing.

5. Slowly turn the water filter 90º clockwise to align with the printing mark on the cover, locking the filter in position. Make sure to align the water filter label mark with center of cover filter printing as illustrated. Remember, do not over- tighten.

Separation of red cap.

You should remove the right side upper glass shelf before installing water filters.

Turn until the label aligned.

Removing any residual matter inside the water supply line after installing the water filter.

1.Turn ON the main water supply & turn OFF the valve to the water supply line.

2.Run water through the dispenser until the water runs clear (approx. 6-7 minutes). This will clean the water supply system and remove air from the lines.

3.Additional flushing may be required in some households.

4.Open the Refrigerator door and make sure there are no water leaks coming from the water filter.

One Touch Pure Water

Be sure to flush the dispenser thoroughly or water may drip from the dispenser.

This is due to the fact that there is still air in the line.

Test button

CAUTION In case ice doesn’t come out, pull out the ice bucket and press test button located on the right side of ice maker.

Test button

Reverse Osmosis Water Supply

IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

•Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.

•Allow the storage tank on the reverse osmosis system to refill after heavy usage.

•If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call a licensed, qualified plumber.

18_ Setting Up

DA68-01812H.indb 18 2009.8.10 9:4:33 AM