SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational.
1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest | Hex wrench | Compression | Compression | |
temperature and wait for an hour. The Freezer will | fitting | nut | ||
| ||||
get slightly chilled and the motor will run smoothly. |
|
|
| |
4. After powering the Refrigerator, it will take a few | Water filter |
|
| |
hours to reach the appropriate temperature. You |
|
| ||
can store food and drinks in the Refrigerator once | Fastener | Washer |
| |
the temperature is sufficiently cool. | ||||
|
|
| ||
Check the accessory list below.
Removing the refrigerator doors
If your entrance won’t allow the Refrigerator to pass easily Tools you will need through it, you can remove the doors.
Philips screwdriver | 10mm Socket Wrench | Allen wrench(5mm) |
Pliers |
|
PU 01SETTING
Disassemble the Refrigerator doors
1.With the door closed, remove the top table( 1 ) using a Philips screwdriver, and then disconnect the wires( 2 ). Remove hinge screws( 3 ) and ground screw( 4 )
1
3
4
2
2. Lift the door straight up to remove.
3.With a Philips head screwdriver, remove the two screws( 10 ) attached to the lower left and right door hinges.
With an Allen Wrench(5mm), remove the two hex head bolts( 11 ) attached to the lower left and right door hinges.
Remove the lower left and right door hinges( 12 ).
12
10
11
Setting Up _9
2009.8.10 9:4:5 | AM | |
|
|
|
