To connect the water filtering hose to the water line
a
A
a
B
Remove cap
a
03
1. | Loosen and remove the compression |
| nut (a) from the water line of the |
| refrigerator, and insert it to the water |
| filtering hose. |
2. | Tighten up the compression nut (a) to |
| connect the water filtering hose and the |
| water line. |
3. | Open the main water valve and check |
| for any leaks. |
4. | If there are no leaks, dispense about a |
| 3 liters of water before actually using |
| the refrigerator to remove impurities |
A.Water Line from unit
B.Water Line from Kit
To repair the water line
CAUTION
inside the water filtering system. |
Installation
The waterline must be repaired by a qualified professional. If you encounter a water leak, contact a local Samsung service centre or the installer of the waterline.
STEP 7 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.Plug the power cord into the wall socket to turn the refrigerator on.
2.Open the door, and check if the interior light lights up.
3.Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be slightly chilled, and the motor will run smoothly.
4.Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready for use.
STEP 8 Final check
When installation is complete, confirm that:
•The refrigerator is plugged into an electrical outlet and grounded properly.
•The refrigerator is installed on a flat, level surface with a reasonable clearance from the wall or the cabinet.
•The refrigerator is level and is sitting firmly on the floor.
•The door opens and closes freely, and the interior light turns on automatically when you open the door.
English 39
|
| ||
|
| ||
|
|
|
|