Twist Ice Maker Model
1.Pull out the
2.Fill trays up to the water level mark(arrow).
3.Put the
4.Once the water has become frozen, turn the dials on the Ice cube trays to empty Ice cubes into the storage bin.
1 | 2 |
3
4
REMOVING AND RELOCATING THE FRIDGE ACCESSORIES
1. Door Bins
To remove - Simply lift the bin up and pull straight out.
To replace - Slide it in above the desired location and push down until it stops.
Injury may occur if the door bins are not fi rmly CAUTION inserted. Do not allow children to play with
3. Vegetable & Fruit Drawers | 1 |
| |
To remove - Pull the drawer out |
| ||
to full extension. |
|
| |
Tilt up the front of |
|
| |
the drawer and pull |
|
| |
straight out. | 2 |
| |
To replace - Insert the drawer |
| ||
|
| ||
into the frame rails |
|
| |
and push back into |
| 02 | |
place. |
| ||
| OPERATING | ||
The drawers need to be removed before the | |||
| |||
glass shelf above them can be lifted out.
To get the best energy effi ciency of this product, please leave all selves, drawers and baskets on their original position like as illustration in page 15
REMOVING THE FREEZER ACCESSORIES
1. Pull Out Drawer
To remove - Pull the drawer out to full extension. Tilt up rear of drawer and lift straight out. (Refer to picture 1 & 2)
Open the freezer door fully and remove the drawer.
To replace - Place the drawer onto the rails by tilting it up. Lower the drawer into place until it is horizontal and slide the drawer in.
(Refer to picture 3)
bins. Sharp corners of the bins may cause
injury.
Empty the bin before adjusting it.
Dust removal method
2. Fridge shelves
To remove - When pulling out the shelf, if it does not slide out easily, lift it
1 |
1 |
2 |
2 |
3 |
3 |
up slightly and pull out again.
To replace - When pushing in the shelf, if it does not slide in easily, lift it up slightly and push in again.
The Glass shelves are heavy.
2.Freezer Drawer Bin Swing-Type
To remove - Pull the drawer out fully. Tilt up the rear of the bin and lift it out to remove.
1 |
CAUTION Use special care when removing them.
To replace - Place the bin into the | 2 | |
rail assembly. | ||
| ||
When replacing, place the drawer |
| |
bin holder into the hole of the rail |
| |
| operating _17 |
2011.7.4 9:22:13 PM |
