REATTACHING THE REFRIGERATOR DOORS
3
4. Connect the water line ( 5 ) and then insert a clip | 4 |
on the coupler with pulling tube. Connect the one connector ( 4 ) on left side door, the other connector
(7 ) on right side door and two connectors ( 3 ) at
each side of the top cap.
7 3
The clip is enveloped inside of the top cap.
5
| Type A | Type B |
| • The Water Line must be fully inserted to the |
|
CAUTION | center of transparent coupler (Type A) or the |
|
| line (Type B) to prevent water leakage from the | Dispenser |
| dispenser. |
|
| • Insert the clip in the install pack and check that |
|
| Center of Transparent coupler | The Guide Lines |
| it holds the line fi rmly. | |
|
| |
| clip A (1/4”) | clip A (1/4”) |
| (6.35mm) | |
| (6.35mm) | |
|
|
01 SETTING UP
5.Position the top table ( 2 ) in place. Insert and tighten the 3 screws into the top table with a philips screw driver(+). After door opened, reinsert the cap top table ( 1 ) and close the doors.
When reattaching the top table, make sure that the wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see whether the door has gaps between gaskets or is tilted. If you see one of them, please refer to “Adjusting the doors” page on 15.
2
1
Setting Up _13
2014. 5. 8. 4:39 |
