SETTING UP THE REFRIGERATOR
Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1.Place the refrigerator in an appropriate location with reasonable clearance between the walls and the refrigerator.
Refer to installation instructions in this manual. (page 9, Selecting the best location for the refrigerator)
2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly.
4.After powering the refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is suffi ciently low.
Check the accessories listed below.
01 SETTING UP
Water fi lter | Hex wrench | Fastener |
Required Tools(Not provided)
Philips screwdriver(+) | Pliers | Allen wrench(3/16”) |
|
| (5mm) |
REMOVING THE REFRIGERATOR DOORS
Some installations require door removal to transport the refrigerator to its fi nal location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer, make sure you read following items.
Disconnect power to the refrigerator before removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch the door/drawer while removing them.
•Be careful not to get injured while removing the door/drawer.
•Reattach the door/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors while WARNING removing the doors.
Disassemble the refrigerator doors
1.With the door opened, remove the hinge top table ( 1 ) with a fl
( 2 ) and remove it.
2
1 
Setting Up _9
2014. 5. 8. 4:39 |
