Samsung RFG29PEPN1/SML Adjusting the Freezer Drawer Level, Installing the Water Dispenser Line

ADJUSTING THE FREEZER DRAWER LEVEL

Adjustment part

Freezer Drawer

1.Locate the height-adjuster ( 1 ) in the freezer drawer.

Unscrew the four Phillips screws ( 2 ) slightly to loosen the door.

1

2

2.Loosen the controller screw ( 3 ) with a Phillips screwdriver (+).

3

3.Find the best level to align the door slope.

• After adjustment, tighten the

controller screw and then the philips screws.

Example) The slope is about 0.08inch (2mm) as shown below. - Rotate the height adjuster to -2.0 to reduce the door slope.

Slope

Reference plane

INSTALLING THE WATER

DISPENSER LINE

A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote	up
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.	01setting
In order for the ice maker to operate properly, a
water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be filled in about 10 seconds.

If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.

After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water line installation kits are include with unit. You can find it in freezer drawer.

The new hose-sets supplied with the appliance are to be used and that old hose- sets should not be reused.

Parts for water line Installation

Water line fixer and screws	Pipe connector
Water line

setting up _11

DA99-03957C-06.indb 11 2015. 5. 7.

�� 3:51