Samsung RFG29PEPN1/SML manual Severe Warning Signs for Warning Installation

-- Never start up an appliance showing any signs of damage. If in doubt, consult your dealer. The room where the refrigerator will be sited must be 1 m³ in size for every 8 g of R-600a refrigerant inside the appliance. The amount of refrigerant in your particular appliance is shown on the identification plate inside the appliance.

-- If the appliance contains isobutane refrigerant (R-600a), a natural gas with high environmental compatibility that is, however, also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged.

SEVERE WARNING SIGNS FOR WARNING INSTALLATION

•Do not install this appliance in a humid, oily

or dusty location, in a location exposed to direct sunlight and water (rain drops).

-- Deteriorated insulation of electrical parts may cause an electric shock or fire.

•Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliances.

•Do not plug several appliances into the same multiple power board.

The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matched the rating plate.

-- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire hazard from overheated wires. If the wall socket is loose, do not insert the power plug.

-- There is a risk of electric shock or fire.

•Do not use a cord that shows cracks or abrasion damage along its length or at either end.

•Do not bend the power cord excessively or place heavy articles on it.

•Do not use aerosols near the refrigerator.

-- Aerosols used near the refrigerator may cause an explosion or fire.

•Do not install this appliance in a location where gas may leak.

-- This may result in an electric shock or fire.

•The installation or any service of this appliance is recommended by a qualified technician or service company.

-- Failing to do so may result in an electric shock, fire, explosion, problems with the product, or injury.

•This refrigerator must be properly installed and

located in accordance with the manual before it is used.

•Connect the power plug in proper position with the cord hanging down.

-- If you connect the power plug upside down, wire can get cut off and a cause fire or an electric shock.

•Make sure that the power plug is not squashed or damaged by the back of the refrigerator.

•When moving the refrigerator, be careful not to roll over or damage the power cord.

-- This constitutes a fire hazard.

•The appliance must be positioned so that the plug is accessible after installation.

• The refrigerator must be grounded. -- You must ground the refrigerator to

prevent any power leakages or electric shocks caused by current leakage from the refrigerator.

•Never use gas pipes, telephone lines or other potential lightening rods as ground.

-- Improper use of the ground plug can result in an electric shock.

•If the power cord is damaged, have it replaced immediately by the manufacturer or its service agent.

•The fuse on the refrigerator must be changed by a qualified technician or service company.

-- Failing to do so may result in an electric shock or personal injury.

CAUTION SIGNS FOR

CAUTION INSTALLATION

•Keep ventilation opening in the appliance enclosure or mounting structure clear of obstruction.

•Allow the appliance to stand for 2 hours after installation.

SEVERE WARNING SIGNS FOR

WARNING USING

•Do not insert the power plug with wet hands.

•Do not store articles on the top of the appliance.

-- When you open or close the door, the articles may fall and cause a personal injury and/or material damage.

•Do not put items filled with water on the refrigerator.

safety information _03

DA99-03957C-06.indb 3 2015. 5. 7.

�� 3:51