USER INTERFACE
How to connect the AM Antenna.
The AM antenna can be :
-Placed on a stable surface.
-Fixed to the wall/base/floor, etc. (you must first remove/clean the base)
To assemble the AM loop antenna.
To connect the AM loop antenna cords.
- Connect black cord to the black terminal, and the white cord to the white terminal.
To avoid noise interference.
-Check that electronic equipment and DC adapter do not run close to the antenna wires. Always keep them at least 20 inches (50cm) away.
How to connect the FM Antenna.
-Connect a 75( ) antenna to the FM antenna terminal.
-Plug the connector on the FM antenna supplied into the coaxial socket (75 ) marked FM on the rear of the system.
-Follow the instructions to tune into a radio station, and deter- mine the best position for the antenna.
1.Extend the FM antenna.
2.Fasten it up in the position which gives you the best reception, then fix it on the wall, etc.
-If reception is poor, you may need to install an outdoor antenna. To do so, connect an outdoor FM antenna to the FM socket on
the rear of the system using a 75 coaxial cable(not supplied).
How to improve the Radio reception.
You can improve the quality of radio reception by :
-Spread the AM/FM antenna out and attach the ends to a wall, in the position providing the best reception.
-If reception is poor (e.g. distance from transmitter too close, walls blocking the radio waves, etc.), install an outdoor antenna.
- AM/FM Radio reception quality will depend on your location and the broadcast conditions.
NOTE
54