INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
1)Slip the compression nut through the provided plastic tubing.
2)Tighten the compression nut onto the 1/4” compression fitting.
| Refrigerator |
Ferrule | Compression Nut (1/4 |
(Purchased) | |
| (Provided) |
NOTE
Do not overtighten the compression nut.
Using Copper Tubing
-Slip the compression nut and ferrule on copper tubing as shown.
Using Plastic Tubing
-Insert the molded end of the plastic tubing into the compression fitting.
3)Tighten the compression nut onto the com- pression fitting.
4)Turn water on and check for any leakage.
| Compression Fitting |
| (Provided) |
| Compression Nut (1/4 |
| (Purchased) |
Copper Tubing | Plastic Tubing |
(Purchased) | |
(Purchased) |
|
Household Water Line
Water line must be connected to drinkable water only.
NOTE Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnecting.
Install the water filter.
1)The water filter is located in the upper right hand corner of the refrigerator. Remove the fixed cap (A) as shown. The fixed cap separates from the Water Filter Compartment by rotating it coun- terclockwise.
Keep the cap(A) in a safe place for recapping, when you NOTE don’t need to use the filter.
Remove the water filter from the box and put a month indicator stick on the filter as shown.
2)If the water filter was installed in March, put on the "SEP" sticker.
3)Remove the Red protective cap from the filter, then position and
insert the filter as shown.
4) Slowly turn the water filter clockwise 90º to align the indication mark on the cover, locking the filter in position. Do not overtighten.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
(A)
COVER FILTER
ALIGN THE INDICATION MARK WITH LOCK POSITION.
INSTALLATION INSTRUCTIONS
27