Before calling service
Removing residual matter inside the water supply line after installing filter.
1.Turn ON the main water supply.
2.Push the Dispenser Lever.
3.Flush 1 gallons of water through the filter before use. (Flush approximately 6 minutes.)
This will clean the water supply system and remove air from the lines.
4.Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
up setting
Ice Chute
Figure 3
•When Ice Off blinks on the display panel, CAUTION reinsert the bucket and/or make sure it’s
installed properly.
•When the door is open, the Ice and water dispenser do not work.
•If you close the door hard, it may cause water spilling over the ice maker.
•To prevent dropping the ice bucket, use both hands when removing it.
•To prevent injury, be sure to clean up any ice or water that may have dropped on the floor.
•Do not let the children hang on the ice dispenser or on the bucket.
They may get hurt.
•Be sure not to put your hand or any object into the ice chute.
It may cause personal injury or damage mechanical parts.
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser.
This is due to air getting into the line.
It should pose no problem to operation.
English - 27
2017. 7. 7. |
�� 10:14