![](/images/new-backgrounds/1238090/2380909x1.webp)
DISMOUNT METHOD OF ATTACHMENT
Use of accessories
| Twist icemaker for Ice making |
| - Insert water at room temperature into the twist icemaker |
| until the water reaches the water line; |
Water line | - Press the twist icemaker gently into the ice making shelf; |
| - When taking out the ice, rotate the twist icemaker |
Twist icemaker | clockwise to the end and release it to rebound. That will |
button | separate the ice cubes from the ice tray easily and the ice |
| |
| can be stored in the Ice Storage tray directly; |
Wine Shelf
Disassembly of accessories
Refrigerator shelf
Lift the rear of the refrigerator shelf to take it out.
Vegetable crisper and cover
Pull the vegetable crisper till the limit to take it out.
Lift the rear of the Vegetable crisper cover to remove it.
Freezer drawer
Pull it outside to the limit stop and raise, then it can be taken out.
Big Bottle Guard | Dairy Tray and Can guard |
Lift it upward to remove it.
Replacing the refrigerator lamp
Remove the power plug.
Loosen off the screw at the back of lamp cover with the philips driver. Squeeze the lamp cover with both hands to deform it slightly to remove it.
Remove the bulb by turning anticlockwise.
Install the new bulb by turning clockwise.
First lock the hook at the front of the lamp cover, then lock the hook at the back of the lamp cover. And finally tighten the screw.
Lamp parameter: 220V/240V,25W E14
SAFETY NOTES
PRECAUTIONS
-When comparing rated refrigerators, please check the refrigerator type and serial number.
-Before connecting the power, please check if the refrigerator voltage range is compliant with the supply voltage. The voltage range is
-When the refrigerator is connected, the food should not be put into it until it is cooled completely;
-During power failure, the refrigerator should not be connected until five minutes later to avoid any damage to the compressor;
-Do not touch the evaporator of the freezer with wet hands in case the water on the hand freezes and sticks;
-Do not put foodstuff near the temperature sensor to avoid affecting the correct display of temperature;
-It is not necessary to leave the door open for a long period or frequently open and close in
-Keep in mind not to overturn the refrigerator or position horizontally. When it is necessary to incline,the slope between the refrigerator body and the ground should be larger than 45
degrees;
-Do not move the refrigerator with the door handle or pull the handle up and down with extreme force;
-Please close the drawer before closing the refrigerator door to avoid damaging the drawer;
-When a lot of hot things are put into the refrigerator once or the door is open frequently or left open for a long period , the temperature in the refrigerator will increase and the tempe- rature display will flash. Usually it will return to normal within 24 hours;
WARNING
-Keep ventilation openings, in the appliance enclosure or in the
-Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
-Do not damage the refrigerant circuit.
-Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
PRE-RUNNING ISSUES ![](/images/new-backgrounds/1238090/2380909xi10.webp)
1. Disassemble all packaging components. The foam bottom mat must be removed before operating the unit.
2. Wipe the inner and outer of the refrigerator with warm and wet cloth (It is advisable to add a little neutral cleanser to the warm water).
3. Let it stand for about 1 hour and then plug in.
Be careful to operate correspondingly in accordance with the content on the refrigerator display window.
11 | 4 |