Samsung RS25H5223SP/ML manual Replacing the Water Filter

REPLACING THE WATER FILTER

Replace the water filter when the water filter indicator turns red.

The water filter is located on the bottom right side of the refrigerator.

To make changing the water filter easier, you may want to shut off the water supply, and then drain any water remaining in the water line by pressing the Water button and then pressing a glass against the water dispenser pad.

1. Turn the water filter 90˚ counter-clockwise.

5.Press and hold the Water button for 3 seconds after changing the filter to reset the filter indicator.

Confirm the indicator turns blue.

When you replace the water filter, some water may leak from the water filter housing.

Make sure to wipe up any leakage that may have occurred.

Removing residual matter from inside the water supply line after installing a new filter

maintain

U C

N

LO

K

LOCK

LOCK

Ice

Water

2. Pull the water filter out of the filter housing.

U

NLOC

K

LOCK

OCK

L

3. Insert a new water filter into the filter housing.

UN

LOCK

K

C

LO

LOCK

4. Turn the new water filter 90˚ clockwise.

UNLOCK

LOCK

LOCK

1.Turn ON the main water supply.

2.Press the Water button on the control panel. Place a cup or glass under the water outlet, and then push the cup or glass against the dispenser pad until you hear a "click".

3.Flush 3 gallons of water through the filter. (Flush approximately 6 minutes.)

This will clean the water supply system and remove air from the lines.

4.Additional flushing may be required in some households.

5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.

A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser.

This is the result of air getting into the line. It poses no problem to the operation of the refrigerator.

English - 35

DA68-02981D-00.indb 35 2014. 1. 27.

�� 3:25