CHECKING THE WATER DISPENSER LINE (OPTIONAL)

A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet. When using the Water Dispenser, Slight noises can be generated from supplying water.

Water Line installation Kits are included. You can fi nd it in one of the freezer drawers.

USING THE ICE MAKER (OPTIONAL)

(RS77*, RS54H*, RS76*)

To Remove the Ice Bucket

- Hold the handle as shown in fi gure1.

-Slightly pull up the bottom part.

-Take out the ice bucket slowly.

To Refit The Ice Bucket

-Assemble it in the reverse order of disassembly.

- Push the bucket in fi rmly until

Figure1

you hear a clicking sound.

 

- When the bucket does not fi t

 

into its place, turn the gear

 

handle on its back by 90

 

degrees and reinstall it again

 

as shown in fi gure 2.

 

Normal Operation

- Any sounds you hear when the ice

maker dumps ice into the bucket

Figure2

are part of normal operation.

 

- Not dispensing ice for long

 

periods may cause ice

 

clumps in the ice bucket.

 

Remove the remaining ice

 

and empty the bucket.

 

- When ice does not come out,

 

Check for any ice stuck in the

 

chute and remove it.

 

- The fi rst batch of ice cubes may

 

be small due to air in the pipe

Ice Chute

after connection, any air will be

 

purged during normal use.

 

- When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s

CAUTION installed properly.

-When the door is open, the Ice and water dispenser do not work.

-If you close the door hard, it may cause water spilling over the ice maker.

-To prevent dropping the ice bucket, use both hands when removing it.

-To prevent injury, be sure to clean up any

ice or water that may have dropped on the fl oor.

-Do not let children hang on the ice dispenser or on the bucket.

They may get hurt.

-Be sure not to put your hand or any object into the ice chute.

It may cause personal injury or damage mechanical parts.

Check the amount of water supplied to the ice tray.

(RS7547*/ RS755* / RS756* / RS757*)

1. Lift up the icemaker cover and gently pull out.

2. When you press the Test button for 3 seconds, the ice cube container is fi lled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem from with in the main water pipes, not the refrigerator.

1

Ice maker

Feeler Arm

Check the water level

Test button

2

English - 20

DA68-02710A (EN)-14.indd 20

2017. 8. 5. ￿￿ 9:35