Samsung RSG309AARS user manual Installing the water line, Before using icemaker

Figure 1

Figure 2

Ice Chute

Installing the water line

Connecting the water line to the Refrigerator.

There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store.

•	1/4” compression nut	•	plastic tubing
•	copper tubing	•	ferrule

Refrigerator

line, cut off 1/4“ of the plastic tubing to make sure you get a snug, leak-free connection.

before using icemaker

Remove

- Hold the handle as shown in Figure1.

-Slightly pull up the bottom part.

- Take out the ice bucket slowly.

Install

- Assemble the icemaker in the reverse order of disassembly.

- Push the bucket in firmly until you hear a clicking sound.

Plastic tubing (Assembled)

Ferrule (Not supplied)

Compression nut (1/4”)

(Assembled)

Compression

fitting

(Assembled)

Molded end(Bulb)

Compression nut (B) (1/4”) (Not supplied)

- If the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in Figure 2.

Before calling service

-Any sounds you hear when

the ice maker dumps ice into the bucket are part of normal operation.

- If you don’t dispense ice for a

Copper tubing	or	Plastic tubing (B)
(Not supplied)		(Not supplied)

Household water supply line

1.Connect the household water line to the assembled compression fitting.

-If you are using copper tubing, slip the compression nut (B) (not included) and ferrule (not included) on copper tubing (not included) as shown.

-If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B) into the compression fitting.

Do not use without the molded end(Bulb) of CAUTION the plastic tubing (B).

2.Tighten the compression nut (B) onto the compression fitting. Do not over-tighten the compression nut (B).

3.Turn water on and check for any leakage.

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water

10_ setting up

long period of time, the ice may

form clumps in the ice bucket. If ice clumps form, remove the remaining ice and empty the bucket.

-When ice does not come out, check for ice stuck in the chute and remove it.

-When Ice Off blinks on the display panel,

CAUTION	reinsert the bucket and/or make sure it’s
	installed properly.

-When the door is open, the Ice and water dispenser do not work.

-If you close the door hard, it may cause water spilling over the ice maker.

-To prevent dropping the ice bucket, use both hands when removing it.

-To prevent injury, be sure to clean up any ice or

water that may have dropped on the floor.

-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.

-Be sure not to put your hand or any object into the ice chute. It may cause personal injury or damage mechanical parts.

DA68-02500B.indb 10 2012.6.7 1:40:3 PM