Samsung RSG309AARS user manual Levelling the refrigerator

Reattaching the freezer doors

To reattach the freezer doors, replace parts in reverse order

Reattaching the Water Supply Line

1.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.

2.Insert the 2 clips in the install pack and check that each clip holds the line firmly.

Center of transparent coupler

clip A (¼”) (6.35mm)

Do not cut the water line. Gently separate it from the coupler.

Removing the Fridge Door

1.Remove a screw on the upper hinge cover 1 . With the door open, disengage the two locking tabs with a flat-head screw driver 2 and remove it while the lifting up the rear of the cover 3 , and then disconnect the wires by gently pulling them apart 4 .

1

3

4

2

2.Removing the FIXER HINGE ,and next take off the upper hinge. Be careful that the door does not fall on you as you are removing it.

3. Remove the door from the 6

lower hinge 5 by lifting the door straight up 6 .

5

Reattaching the Fridge door

To reattach the fridge doors, replace parts in reverse order.

LEVELLING the refrigerator

Now that the doors are back on the refrigerator, you want to make sure the refrigerator is level so that you can make final adjustments. If the refrigerator is not level, it will not be possible to get the doors perfectly even.

When the Freezer part is lower than the Fridge part.

Insert a flat-blade screwdriver into a slot on the Freezer Leg, then turn it clockwise.

Screw Driver Freezer Leg

When the Fridge part is lower than the Freezer part.

Insert a flat-blade screwdriver into a slot on the Fridge Leg, then turn it clockwise.

Be sure to keep track of all parts you are removing.

08_ setting up

Fridge Leg Screw Driver

Refer to the next section for the best way to make very minor adjustments to the doors.

DA68-02500B.indb 8 2012.6.7 1:39:59 PM