Samsung RSG309AARS user manual setting uP tHe ReFRigeRAtoR, SETTING UP the refrigerator doors

setting uP tHe ReFRigeRAtoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user’s guide. If you have any further questions, contact your Samsung Electronics service center.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.

SETTING UP the refrigerator doors

If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.

Removing the freezer door

A few things to mention first.

•Make sure that you lift the door straight up so the hinges are not bent or broken.

•Be careful not to pinch the water tubing and wire harness on the door.

•Place doors on a protected surface to prevent scratching or damage.

1.Remove a screw on the upper hinge cover 1 . With the door open, disengage the two locking tabs with a flat-head screw driver 2 and remove it while the lifting up the rear of the cover 3 , and then disconnect the wires by gently pulling them apart 4 .

1

3

4

2

2.Removing the FIXER HINGE ,and next take off the upper hinge. Be careful that the door does not fall on you as you are removing it.

p u 01setting

Separating the Water Supply Line from the Refrigerator

1.Pull the two water lines (which are in the Fixer) out to the front.

Be sure to keep track of all parts you are removing.

3.Next, remove the door from the lower hinge 5 by carefully lifting the door straight up 6 .

2.Remove two water lines (White one is for water and the other one is for ice) by pressing the coupler 1 and pulling the water line 2 away.

1

Make sure the color of the water lines match.

2

6

5

Be careful not to pinch the water tubing and wire harness on the door.

setting up _07

DA68-02500B.indb 7 2012.6.7 1:39:49 PM