Samsung RSG5 Removing any residual matter inside the water, supply line after installing filter

Models: RSG5

1 36
Download 36 pages 25 Kb
Page 18
Image 18
Removing any residual matter inside the water

4. Remove the filter cap and insert the

 

 

 

filter into the filter housing.

4

Cover filter

5

5. Slowly turn the water filter 90º

 

 

 

clockwise to align with the printing

 

 

 

mark on the cover, locking the filter

 

 

 

in position. Make sure to align the

 

 

 

water filter label mark with center

 

 

 

of cover filter printing as illustrated.

 

 

 

Remember, do not over-tighten.

 

Separation

Align the indication

 

 

 

 

of red cap

mark with lock position

Removing any residual matter inside the water

 

supply line after installing filter.

Ice

1.

Turn ON the main water supply.

 

2.

Press the Water button and push the dispenser pad.

 

3.

Run water through the dispenser until the water runs clear

 

 

(approx. 3L). This will clean the water supply system and

 

 

remove air from the lines.

 

4.

Additional flushing may be required in some households.

 

5.

Open the refrigerator door and make sure there are no water

 

 

leaks coming from the water filter.

 

A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.

Check the amount of water supplied to the ice tray.

Water

1. Lift up the icemaker cover and gently pull out.

2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct(see the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem from with in the main water pipes, not the refrigerator.

1

 

 

Check the water level

 

Ice maker

2

 

 

 

 

Test button

 

- It will take a few minutes to reach the amount of water you want.

CAUTION

- Do not press the test button continuously when the tray is filled with ice or water as

 

illustration below. Water may overflow or ice jamming may occur.

-When the bucket is not installed, the ice maker does not work.

-When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s installed properly.

18_ setting up

Page 18
Image 18
Samsung RSG5 user manual Removing any residual matter inside the water, supply line after installing filter, setting up