INSTALLING THE WATER DISPENSER LINE
Connecting the water line to the refrigerator
1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.
2.Connect both water line from the unit and water line in the kit
3.Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4.Turn water on and check for any leakage.
Loosen a | Remove | |
cap | ||
|
Removing any residual matter inside the water supply line after installing filter.
1. Turn ON the main water |
Water Line |
from unit |
Water Line |
from Kit |
No gap |
supply. | Water |
2. Press the Water button and | Ice |
push the dispenser pad. |
|
3.Run water through the dispenser until the water runs
clear (approx. 3 L). This will clean the water supply system and remove
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5 mm of the plastic tubing to make sure you get a snug,
Before being used, the leakage in these CAUTION places should be examined
•Samsung Warranty does not cover WATER LINE INSTALLATION.
•It’ll be done at customer’s charge unless the retail price includes installation cost.
•Please contact Plumber or Authorized Installer for the installation if needed.
•If Water leakage occurs due to improper installation, Please contact installer.
air from the lines.
4. Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
English - 24
2017. 5. 22. 2:38 |
