11.Channel (Refer to "Making wireless presentation" on page 30 for more information.) When the Wireless Connection menu is displayed, press this button to change the wireless connection channel.
12.Auto (Refer to
13.Source (Refer to "Switching input signal" on page 26 for more information) Sequentially selects input sources.
14.Blank (Refer to "Switching input signal" on page 26 for more information.)
Used to hide the screen image. Press Blank again to restore the image.
15.Mode (Refer to "Application Mode" on page 38 for more information.)
Depending upon which input signal is selected, there are several picture setup options available.
Remote control effective range
6 M
Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the
Installing or replacing the remote control battery
1. Pull out the battery holder.
2. Insert the new battery in the holder. Note that the positive polarity should face outward.
3. Push the holder into the remote control.
• Avoid excessive heat and humidity.
•There may be danger of damage to the remote and injury to those nearby if the battery is incorrectly replaced.
•Replace only with the same or equivalent type recommended by the manufacturer.
•Dispose of the used battery according to the manufacturer’s instructions.
•Never throw a battery into a fire. There may be danger of an explosion.
•If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to the remote control from possible battery leakage.
