positioner model:
For models fitted with the integrated positioner module, refer to the following instructions for positioner setup (assuming your dish has already been correctly setup):
At the back of the receiver you will find eight connectors provided for the dish actuator -
M1, M2, SENS, GND:
From your actuator motor you will find four wires – two thick and two thin wires. Connect the two thick motor wires to M1 and M2, the two thin sensor wires to SENS and GND.
0/12V, GND:
Where applicable, connect a 0/12V LNB switch to these two connectors.
+5V, PULSE, GND:
Where applicable, connect a mechanical polariser to these three connectors.
Positioner setup:
With the receiver in analogue mode, press the
INFO/POS key to enter the positioner menu:
SAT No: | SAT POSITION |
| ||
Select between | SAT NO | 01 | ||
SAT Name: | ||||
SAT NAME | ARAB 2A,3A | |||
Displays the satellite name. You may move the cursor | ||||
SAT STORED | NO | |||
into the name field to edit the satellite name. | DISH POSI | 5000 | ||
SAT STORED: | EAST LIMIT | 0001 | ||
When SAT STORED = NO, all channels with the same | WEST LIMIT | 9999 | ||
satellite name will be assigned to this satellite position. | REALIGN | 01 | ||
DISH POSITION: | CLEAR LIMITS |
| ||
Displays the current dish position. | UP/DN, LEFT/RIGHT, OK, ESC | |||
EAST LIMIT: | ||||
|
| |||
You may store the current dish position as the East limits |
|
| ||
|
| |||
by moving the cursor here and press STORE. |
|
| ||
WEST LIMIT: |
|
| ||
You may store the current dish position as the West |
|
| ||
limits by moving the cursor here and press STORE. |
|
| ||
REALIGN: |
|
| ||
If for any reason your dish is out of alignment with the |
|
| ||
satellites, use this function to realign all satellites in one |
|
| ||
operation instead of realigning the satellites individually. |
|
| ||
1. | First select a satellite you wish to realign as |
|
| |
| reference. |
|
| |
2. | Move the cursor to DISH POSITION |
|
| |
3. | Move the dish East or West to relocate the |
|
| |
| reference satellite. |
|
| |
4. | Move the cursor to REALIGN and press STORE |
|
| |
5. | Now all other satellite positions will be realigned |
|
| |
| with respect to the reference satellite. |
|
|
32