Samsung SADPCI-202 instruction manual Quick Start, Manual Entry see also “Advanced User Guide”

Quick Start:

After initialisation, the Language selection screen will be displayed.

By using the LEFT/RIGHT keys, you may select the different menu languages available. Once you have selected the desired menu language, press OK to continue with set-up.

Select Menu Language

English

After selecting the menu language, the receiver will display the Channel Tuning Menu: (Menu, Channel Setup, OK)

	LNB			A1
	Preset			Setup Satellite
Preset Entry:	Satellite
				Hotbird – 13.0E
Move the cursor to highlight the “Satellite” box and	Frequency
				11720
	Sym. Rate
				27500
use the LEFT/RIGHT keys to scroll through the pre-	Polarity			Hor 18v
	FEC
stored satellites. For example, if your dish is aimed				3/4
at the Astra satellite, when Astra is selected, you
should see both signal meters reading a good signal	Snaigl Found				Signal
level. The receiver will then prompt you to press OK
to start tuning to all the channels on Astra.
	FTA	Off			Data
(See next page)
	Network	Bouquet		PIDs
	Use		to change Satellite
Note:
	F1 – Preset			F2 Mode

1.If you wish to only tune to a specific Network or Bouquet of channels, move the cursor to highlight the “Bouquet” box and use the LEFT/RIGHT keys to scroll through the pre-stored Bouquets. You should now see both signal meters reading a good signal level and the receiver will prompt you to press OK to start tuning all the channels from the selected Network or Bouquet.

2.If you only wish to download Free-to-Air channels, high-light the FTA box and turn the option to “on”.

Provided your dish is installed correctly and aligned to the relevant satellite, both the Signal and Data bars should display a GREEN bar which denotes the following:

The first bar shows the actual satellite SIGNAL strength

You should see a GREEN bar showing your satellite signal is medium to good. If it is RED, this normally indicates that either your dish/LNB set-up is not adequate for this satellite, or your dish is not correctly aligned.

The second bar shows the quality of the DATA received

This GREEN bar indicates the DATA INTEGRITY of the signal received. If the bar is RED, this indicates that the DATA received is unreliable. This could cause the picture to break up, or disappear completely.

Note: If “No signal found” is displayed, check that the values entered are correct and are valid for the satellite your dish is installed for. (Please also refer to the “Advanced Users” and “Trouble Shooting” section to check that your LNB settings are correct).

Manual Entry (see also “Advanced User Guide” ):

(See the “Advanced User Guide” section for more information on manual entry and other tuning options other than Auto set-up.)

8