Samsung SCC-C4307P, SCC-C4207P manual Agc/Motion, White BAL

❙AGC/MOTION

In the AGC (Automatic Gain Control) option, you can specify whether to automatically control the GAIN when the obtained video is below a certain level of brightness because it was recorded under insufficient lighting. To automatically control the GAIN, set the AGC option to LOW or HIGH. Otherwise, set it to OFF. If the you set the AGC option to LOW, the maximum GAIN of the AGC will be set to low, and if set to HIGH, the maximum GAIN will be set to high.

If the SHUTTER option is set to an auto low-speed, the AGC option will change to the MOTION option. In the MOTION option, use the LEFT and RIGHT buttons to select from S.S, SLOW, NORMAL, FAST, and F.F.

CAMERA ID	ON...
IRIS	ALC...
SHUTTER	OFF
AGC	LOW
WHITE BAL	ATW1
FOCUS MODE	AF
MOTION DET	OFF
COLOR/BW	COLOR
PRIVACY	OFF
SPECIAL	...
PRESET	...
EXIT	QUIT

<AGC>

CAMERA ID	ON...
IRIS	ALC...
SHUTTER	AUTOX2
MOTION	S.SLOW
WHITE BAL	ATW1
FOCUS MODE	AF
MOTION DET	OFF
COLOR/BW	COLOR
PRIVACY	OFF
SPECIAL	...
PRESET	...
EXIT	QUIT

<MOTION>

❙WHITE BAL

You can select one of four modes for white balance adjustment as follows:

-ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the color temperature is monitored continuously and thereby white balance is set automatically. The following are the approximate supported color temperature ranges in these modes. ATW1 : 2500K ~ 9300K(✻1)

ATW2 : 2000K ~ 10000K(Mode recommended for sodium	E
lighting)(✻2)

✻1. If the color temperature is out of this range in ATW1 mode, proper white balance may not be obtained. In that case, select ATW2 mode.

✻2. In ATW2 mode, if one color is dominated in the shooted area, the color can be displayed differently. Therefore, select the mode which is appropriate for the environment.

-AWC(Auto-Tracing White Balance Control): In this mode, accurate white balance is obtained by pressing [ENTER] while having a white paper in front of the camera. White Balance data will be maintained after set it once. AWC mode is best in locations where the color temperature of light source is constant.

-MANU : If WHITE BAL menu is set to MANU mode, the user can set the white Balance considering the current illumination. Select MANU item and press [ENTER], the sub screen where you can select Manual White Balance will be shown. Use the left/right keys to select 3200K, 5600K or OFF(USER) mode in the PRESET menu.

✔3200K : Set color temperature to 3200K

✔5600K : Set color temperature to 5600K

✔USER : Choose out a proper value from the RED and BLUE graph for color and temperature setup.

(MANU)
PRESET	OFF(USER)..
RED	(80) ----	I ----
BLUE	(80) ----	I ----
RET

21 22