Samsung SID-500 user manual Reset, Exit, To reset your camera to factory default condition

Operating Your Camera

SYNC : Two synchronization modes are available INTERNAL and EXTERNAL LINE-LOCK. In LINE-LOCK mode, it synchronizes the camera’s video out signal to the external SYNC signal.

SPECIAL		SETUP
USER	PRESET	OFF
PRIVACY		OFF
DAY/NIGHT		COLOR
SYNC		INT
COMM	ADJ
IMAGE	ADJ

•INT : Internal synchronization

•LL : External line-lock synchronization

·If you choose ‘LL’, you can adjust the desired phase. Press the SET button.

· You can adjust the desired phase from 0 to 359.

Notes

•For NTSC models, the line-lock mode can be used if the external SYNC signal frequency is at 60Hz.

•For PAL models, the line-lock mode can be used if the external SYNC signal frequency is at 50Hz.

COMM ADJ: Use this feature to select communication protocol . Position the indicator over 'COMMUNICATION' using the UP or DOWN button.

COLOR CCD CAMERA 40 User’s Manual

•CAM ID : Assign ID number to the camera. It is restricted available to set ID from 1 to 255.

•DISP CAM ID: Displays camera ID on top left corner of the screen.

•BAUD RATE : Configure baud rate from 9600, 19200, 38400, 57600bps.

•UART MODE : Configure parity bit to NONE, EVEN, or ODD. Data bit is set to 8bit, and stop bit to 1bit. Set the UART MODE to EVEN if using the Remote Controller.

•RET PKT : Used to transfer a packet.

•END

IMAGE ADJ: Includes image quality or special function factors.

•FREEZE: Use this feature to freeze capture an image.

•H-REV: Use this feature to horizontally inverse the screen.

•V-REV: Use this feature to vertically inverse the screen.

•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting, however, produces noise and may obscure the image.

•COLOR AGAIN : Adjusting this value affects the chroma level only; the burst level is unaffected.

END: evert back to the USER PRESET menu.

RESET

To reset your camera to factory default condition.

EXIT

To finish setup menu.

COLOR CCD CAMERA 41 User’s Manual