Appendix
How to Clean the Outside | Light Bulb Replacement | |||||||||
Do not use cleaners containing ammonia or alcohol on the microwave | Cooktop Light | |||||||||
oven. Ammonia or alcohol can damage the appearance of the micro- | ||||||||||
wave. | Replace the | |||||||||
| ||||||||||
Case | 1. | To replace the bulb(s), first disconnect the power at the main fuse or | ||||||||
| ||||||||||
Clean the outside of the microwave with a sudsy cloth. Rinse and then |
| circuit breaker panel or pull the plug. | ||||||||
dry. Wipe the window clean with a damp cloth. | 2. | Remove the screw at the front of the light cover and lower the cover. | ||||||||
Control Panel and Door | 3. | Be sure the bulb(s) to be replaced are cool before removing. After | ||||||||
| breaking the adhesive seal, remove the bulb by gently turning. Put in new | |||||||||
Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays, |
| bulb. | ||||||||
4. | Replace the light cover and screw. Connect electrical power to the oven. | |||||||||
large amounts of soap and water, abrasives or sharp objects on the | ||||||||||
|
|
|
|
|
|
|
|
| ||
control panel. |
|
|
|
|
|
|
|
|
| |
Door Surface |
|
|
|
|
|
|
|
|
| |
It’s important to keep the area clean where the door seals against the |
|
|
|
|
|
|
|
|
| |
microwave. Use only mild, nonabrasive detergents applied with a clean |
|
|
|
|
|
|
|
|
| |
sponge or soft cloth. Rinse well. | Oven Light | |||||||||
| ||||||||||
Bottom | Replace the | |||||||||
Clean off the grease and dust on the bottom often. | 1. | To replace the oven light, first disconnect the power at the main fuse or | ||||||||
| circuit breaker panel or pull the plug. | |||||||||
Use a solution of warm water and detergent. |
| |||||||||
2. | Remove the top grille by taking out the 2 screws(on the front of outer | |||||||||
| ||||||||||
|
| case. See page 32 for the Removing Charcoal Filter) that hold it in place. | ||||||||
| 3. | Next, remove the screw located above the door near the center of the | ||||||||
|
| oven that secures the light housing. Remove the housing and bulb. | ||||||||
| 4. | Insert new bulb. Replace the light housing and screw. | ||||||||
| 5. | Replace the top grille and 2 screws, Connect electrical power to the oven. | ||||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
31