-Turns on/off the Video Wall function of the selected monitor.
4) Format
-The format can be selected to see a divided screen.
zFull
zNatural
You may not operate this function in MagicNet.
The Maintenance Control function is available only for the monitors where the power status is ON.
Troubleshooting 1.The monitor you wish to control does not appear on the Power Control Info Grid
-Check the connection of RS232C. (Check if it is properly connected to the Com1 port)
-Check the monitors to see if any of the other monitors connected have the same ID. If more than one monitors
have the same ID, those monitors are not properly detected by the program due to data conflict.
-Check if the monitor Set ID is a number between 0 and 16 . (Adjust using the Display menu)
Note : A monitor Set ID must be a value between 0 and 16 .
2. The monitor you wish to control does not appear on the other Control Info Grids
-Check to see if the monitor power is ON. (You can check this in Power Control Info Grid)
-Check if you can change the input source of the monitor.
3. The dialogue box appears repeatedly.
-Check to see if the monitor you wish to control is selected.
4. Both On Timer and Off Timer have been set but different time is showing.
-Apply current time to synchronize the monitor clocks.
5. The remote may not function properly when you turn off the remote Function, disconnect the RS-232C cable, or exit
the program in an Irregular manner. Rerun the program and turn the remote function again to Restore normal
functions.
<Note>This program may malfunction due to problems in communication circuits or interference from electronic
appliances nearby.
Settings Value display In Multiple Display Mode
When there are more than one monitors connected, the settings values are displayed as follows.
1. No selection: displays the Factory Default Value.
2. Selected one monitor: Fetches and displays the settings value for the selected monitor.
3. Selected one monitor (ID1) and add another monitor (ID3): The program, which was displaying the settings value of
ID 1, fetches and displays the value of ID3.
4. Selected all sets using Select All: Returns to the Factory Default Value.
\X
zt{T[WXXTl__TTUGGG\Xzt{T[WXXTl__TTUGGG\X YWW^TXXTY_GGG㝘㤸GXWaZ_a[]YWW^TXXTY_GGG㝘㤸GXWaZ_a[]