MENU | DESCRIPTION |
|
|
Position | Using this function, you can adjust the screen position if it is not aligned. |
| To adjust, select the direction you want to move the screen, and then press the arrow button pointing |
| in that direction repeatedly. |
|
|
Digital NR | If dotted lines appear in an image or the screen shakes, enabling Digital NR (Noise Reduction) can |
| improve the quality of the picture. |
| When the input signal is a PC Timing |
|
|
Black Level | If the black level is unsuitable for the input signal, the dark parts of an image may look unclear or dim. |
| Using this function, you can select a black level that can improve the visibility of the dark parts. |
| The <Black level> can only be set for the 480i and 576i RGB signals in the [AV], and AV Timing |
|
|
| For [AV], and the 480i and 576i signals of AV Timing |
| • <0 IRE> : Sets the black level to <0 IRE>. |
| • <7.5 IRE> : Sets the black level to <7.5 IRE>. |
| For the RGB signal of <HDMI> mode. |
| • <Normal> : Used in a normal environment. |
| • <Low> : Used when the dark parts of an image are too bright. |
|
|
Overscan | Using this function, you can cut off edge of the a picture when unnecessary information or images |
| appear on the edge of the picture. |
• Overscan is not supported in [AV] modes.
•Overscan is supported only when the input signal is an AV Timing
•If <Overscan> is turned off, unnecessary extra parts at the edges of an image may be shown. In this case, turn <Overscan> on.
Film Mode | Using this function, you can set the display mode so that it is optimized for playing movies. |
| • |
| <Film Mode> is only be supported for the [AV], 480i, and 576i of AV Timing |
|
|
PC | For PC signals, the four PC functions eliminate or reduce noise that causes unstable screen quality, |
| such as screen shaking. If the noise is not removed using Fine Adjustment, adjust the frequency to |
| the maximum and then perform Fine Adjustment again. |
• These functions are only enabled for the PC Timing
•Refer to PC Timing
•<Auto Adjustment> : Used to adjust the frequency and phase of PC screen automatically.
•<Coarse> : Used to adjust the frequency when vertical lines appear on the PC screen.
•<Fine> : Used to fine tune the PC screen.
•<Reset> : Using this function, you can reset the PC menu settings to the factory default settings.
Zoom | You can magnify the screen to a size you want. |
| • <x1> - <x2> - <x4> - <x8> |
| This function is only enabled when the input signal is a PC Timing |
Using |
