Formatting, HDD Alarm, Select Format | Samsung SRD-440 instruction

Formatting

Using the mouse may help make setup easier.

1. Use the up/down buttons ( ) in <Device> window to move to <Storage Device>, and press [ENTER] button.

A window for selection of device for formatting appears.

3. Use direction buttons (	) to select a device to be
formatted.

4.Select <Format> on the bottom of the screen.

Press <OK> on the “Manage” confirmation window will start formatting the selected device.

5.When the formatting is done, press <OK>.

M Even when formatted, used HDD space will not be 0 GB due to the space reserved by the system required for operating.

Storage Device
Device	Format	HDD Alarm
Device	Select	Used/Total	Used
HDD	1	0G/499.49G	Internal
	Manage
	Formatting deletes all recordings.
	Proceed formatting?
	OK	Cancel
Format
	OK	Cancel

You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port, and its duration.

Using the mouse may help make setup easier.

1. Use the up/down buttons ( ) in <Device> window to move to <Storage Device>, and press [ENTER] button.

2.Select <HDD Alarm>.

A window for setting HDD check and replace output ports and their durations appears.

3. Use direction buttons (	) to move to the desired
item.

•Alarm

-Alarm signal will output through the alarm out port on the rear side when selected <1>.

-If <BEEP> was selected, a beep will sound.

-If <All> was selected, both beep sound and alarm signal through rear side ports will output.

•Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specified alarm output port.

•Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified alarm output port.

•Duration : Sets the alarm duration for the alarm signal and beep sound.

English _41