Samsung ST-54T6, ST-62T6 manual Storing Channels in Memory Automatic Method, Press VOL + again

O P E R AT I O N

Storing Channels in Memory (Automatic Method)

1

First, select the correct signal source (ANT, STD, HRC, IRC). See steps 1~4 on previous page.

Press MENU, then press CH ▼ twice to highlight “SET UP.”

Press VOL + to access the SETUP sub-menu. “Channel set up” will be highlighted.

2

Press VOL + while “Channel set up” is high- lighted. A new sub-menu will appear, and “Auto program” will be highlighted.

	SET UP
Channel set up
ANT / CATV	ANT
Time
Convergence
Language	English
Caption
V-chip
Move ± Ent.	Menu

		SET UP
Auto program
Fine tune		00
LNA		Off
Move	± Ent.	Menu

3
	Auto program
Press VOL + again.	ANT 4
The TV will begin	ANT 11
memorizing all of the	+: Stop
available channels.
4
After all the available
channels are stored, the
Auto program menu
reappears. Press Menu
three times to exit.

Note: Channel auto program does not function when the V-chip is active.

▼ The TV automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes.

Press VOL+ at any time to interrupt the memorization process and return to the Setup menu.

3.6 CHAPTER THREE: TV OPERATION