installation & maintenance
HOW TO CONNECT THE DRAIN HOSE
IN CASE OF PUMP-DRAINED WASHER
Take out the
| 90~100cm |
Be sure to join tightly the drain hose into the | Install the drain hose in the position of about |
drainoutlet on the side of the machine. | 90~100cm above the ground. |
HOW TO CONNECT THE DRAIN HOSE
CAUTIONS WHEN INSERTING THE DRAIN HOSE(IN CASE OF GENERAL WASHER)
| Less than 3 m |
|
|
1. | Don’t exceed more than 3m when the drain | 2. | Be careful to drain water out at the end of the |
| hose is used by connecting with other hoses. |
| drain hose. |
| Less than 3 m |
|
|
| Less than |
|
|
| 5 cm |
|
|
3. | The doorsill shoudn’t be more than 5 cm. | 4. | Don’t install the drain hose underneath the |
|
|
| wash machine. |
CONNECTING THE DRAIN HOSE |
| (a) | |
After pressing the joint ring(a), insert the drain hose(b) to drain direction.
HOW TO CLEAN THE PUMP FILTER |
| (b) |
| |
1. | Place a rag under the washer filter not to wet the floor. |
| REAR SIDE | |
| OPEN |
| ||
2. | Rotate the filter counterclockwise and pull out the filter. | FILTER | CLOSE | |
3. | Remove dirts and rotate the filter clockwise until it locks in position. |
| ||
|
|
| ||
12_installation & maintenance
RAG 
|
| ||
|
| ||
|
|
|
|