Samsung owner manual Installation, Mounting the Microphone Holder, Mounting the TRC-445

21-1573.fm Page 5 Thursday, August 5, 1999 9:22 AM

INSTALLATION

MOUNTING THE MICROPHONE HOLDER

Using a Phillips screwdriver and the supplied screws and washers, attach the supplied microphone holder to the CB’s left or right side either horizontally or vertically.

Illustration

Star Lock Washer (2)

Small Screws (2)

MOUNTING THE TRC-445

The most common mounting location for this CB is under a vehicle’s dashboard. However, if you use the TRC-445 as a base station, you can place it on a desk, shelf, or table (see “Using the CB as a Base Station” on Page 8).

If you are mounting the CB in a vehicle, choose a location where:

•You can easily reach the CB.

•Wires and cables are clear of the vehicle’s pedals or other moving parts.

•The CB is not directly in front of heating vents.

•All wires and cables can reach their connection points.

Cautions:

•If you use the TRC-445 in a vehicle, mount it securely to avoid damage to the CB or vehicle or injury to any- one in the vehicle during sudden starts or stops.

•Do not mount the CB where it could damage or interfere with the proper operation of any passive restraint safety device (an air bag or seat belt).

Follow these steps to mount the CB us- ing the supplied hardware.

1.Using the slots in the mounting bracket as a template, mark the positions for the screw holes.

2.In each marked location, drill a hole slightly smaller than the supplied mounting screws.

Caution: Be careful not to drill into anything behind the mounting sur- face.

3.Using a Phillips screwdriver, attach the mounting bracket to the mount- ing surface with the large mounting screws and star lock washers.

Illustration

Star Lock Washer (2)

Mounting Screws (3)

5