English - 19

INSTALLATION

Connecting a Second VCR to Record from the TV

Your TV can send out signals of its picture and sound to be recorded by a second VCR. To do this, connect your second VCR as follows:
1
Connect a set of audio cables between
the AUDIO OUT jacks on the TV and the
AUDIO IN jacks on the VCR. (The VCR
input jacks might be either on the front
or on back of the VCR.)
2
Connect a video cable between the
VIDEO OUT jack on the TV and the
VIDEO IN jack on the VCR.
Refer to your VCR’s instructions for
more information about how to record
using this kind of connection.
TV Rear Panel

Connecting an S-VHS VCR

Your TV can be connected to an S-Video signal from an S-VHSVCR. (This connection deliversa better picture as compared to a standard VHS VCR.)
1
To begin, follow steps 1–3 in the previous
section to connect the antenna or cable
to your VCR and your TV.
2
Connect a set of audio cables between
the AUDIOOUT jacks on the VCR and the
AUDIOIN 1 jacks on the TV.
3
Connect an S-video cable between the
S-VIDEOOUT jack on the VCR and the
S-VIDEO jack on the TV.
TV Rear Panel
An S-video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
AA68-03263C-00_eng_Chapter2 3/11/05 5:39 PM Page 19