Samsung UD46C 106, Connecting to a Wireless Network, Entry process for each field in the 1 min

How to set up manually

1	Go to the Network Settings screen. Select Start, press		, and then press		again.
2	The network test screen appears and the verification process starts. Press Stop. The verification
	process stops.
3	Select IP Settings on network connection screen. The IP Settings screen appears.
4	Select the field at the top, press	, and then set IP Settings to Enter manually. Repeat the
	entry process for each field in the 1 min..
	――Setting IP Settings to Enter manually automatically changes DNS Setting to Enter manually.
5	When done, select OK at the bottom of the page, and then press			. The network test screen
	appears and the verification process starts.
6	When the connection has been verified, the “Wired network and Internet connection
	completed.” message appears.

Connecting to a Wireless Network

To connect your product to your network wireless, you need a wireless router or modem and a Samsung Wireless LAN adapter (WIS10ABGN, WIS12ABGNX) , which you connect to your product back or side panel USB port. See the illustration below.

Wireless IP sharer
(router having DHCP server)
The LAN Port on the Wall	Product Panel
	Samsung Wireles LAN Adapter
LAN Cable

Samsung’s Wireless LAN adapter is sold separately and is offered by selected retailers, Ecommerce sites, and Samsungparts.com. Samsung’s Wireless LAN adapter supports the IEEE 802.11a/b/g and n communication protocols. Samsung recommends using IEEE 802.11n. When you play video over a network connection, the video may not play smoothly.

――You must use the “Samsung Wireless LAN adapter” (WIS10ABGN, WIS12ABGNX) to use a wireless network.

The Samsung Wireless LAN Adapter and the USB extension Cable are sold separately and are offered by select retailers, Ecommerce sites, and Samsungparts.com.

――Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is currently being used by another device nearby, this will result in interference and communication failure.

――Your product supports only the following wireless network security protocols.

If you select the Pure High-throughput (Greenfield) 802.11n mode and the Encryption type is set to WEP, TKIP or TKIP AES (WPS2Mixed) on your AP or wireless router, Samsung products will not support a connection in compliance with new Wi-Fi certification specifications.

――If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC (Push Button Configuration) or PIN (Personal Identification Number). WPS will automatically configure the SSID and WPA key in either mode.

――If your router, modem, or device is not certified, it may not connect to the product via the “Samsung Wireless LAN adapter”.

――Ensure the product is turned on before you connect the “Samsung Wireless LAN adapter”.

――Connection Methods: You can setup the wireless network connection in three ways.

Auto Setup (Using the Auto Network Search function), Manual Setup, WPS(PBC)

106