Introduction
Attaching the function knob to the display
•The function knob can be attached to any screw hole on the display.
•Align the screw holes of the display and function knob. Next, fasten using the screw.
Note
Using a screw other than the one supplied can damage the display.
Detaching the function knob
Hold the area marked in the | Push the areas marked. | Hold the areas marked, and |
picture. |
| lift the function knob. |
Rear
Note
See the "Connections" section for details about cable connections. The LCD Display's configuration at the back may vary slightly depending on the model.
IR OUT
Receives a signal from the remote control and outputs the signal through Loopout when a re- movable sensor board is connected.
CONTROL IN
Connects to the function (Power/Source) control buttons and receives the light sensor signal and remote control's IR signal.
DVI OUT (LOOPOUT)