Connecting to an Antenna

When the TV is initially powered on, basic settings proceed automatically. ✎✎Preset: Connecting the mains and antenna.

VHF/UHF Antenna

Cable

TV Rear Panel

or

Plug & Play (Initial Setup)

When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the POWERPbutton. Plug & Play is available only when the Input source is set to TV.

✎✎To return to the previous step, press the Red button.

1

Selecting a language

2

Selecting Store Demo or

Home Use

3

Selecting a country

4

Setting the Clock Mode

5

Selecting an antenna

6

Selecting a channel

7

Enjoy your TV.

 

 

Press the ▲ or ▼ button, then press the ENTEREbutton.

POWER

Select the desired OSD (On Screen Display) language.

P

Press the ◄ or ► button, then press the ENTEREbutton.

Select the Home Use mode. Store Demo mode is for retail environments.

To return the unit’s settings from Store Demo to Home Use (standard): Press the volume button on the TV. When the OSD volume is displayed,

press and hold MENU for 5 sec.

Store Demo is only for shop display. If you select it, several functions are not able to use. Please select Home Use when you watch at home.

Press the ▲ or ▼ button, then press the ENTEREbutton. Select the appropriate country.

✎✎After selecting the country in the Country menu, some models may proceed with an additional option to setup the pin number.

✎✎When you input the PIN number, 0-0-0-0 is not available. ✎✎The option may differ depending on country.

Set the Clock Mode automatically or manually.

Auto: Select the time zone (depending on the country) where you are located.

Manual: Allows you to manually set the current date and time. Press the ▲ or ▼ button, then press the ENTEREbutton. Select the desired broadcasting signal.

Press the ▲ or ▼ button, then press the ENTEREbutton.

Select the channel source to memorise. When setting the antenna source to Cable, a step appears allowing you to assign numerical values (channel frequencies) to the channels. For more information, refer to Channel → Auto Tuning.

Press the ENTEREbutton at any time to interrupt the memorisation process. Select the Watch TV. Press the ENTEREbutton.

✎✎If you select the Network Settings, set the network. For more information, refer to “Network menu” in the e-Manual.

If You Want to Reset This Feature...

Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”. If you want to change the PIN number, use the Change PIN function.

You should do Plug & Play (MENU → System) again at home although you did in shop.

✎✎If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets the PIN to “0-0-0-0”: MUTE → 8 → 2 → 4 → POWER (on).

English - 6