Using the G-CODE Feature (DVD-V80/ DVD-V85 Only)

VCR

Before presetting your DVD-VCR:

Switch on both the television and your DVD-VCR

Check that the date and time are correct

Insert the cassette on which the programme is to be recorded (safety tab intact)

Up to six programmes can be preset.

1Press the TIMER button.

Result: The TIMER METHOD is displayed.

2

Press the corresponding or buttons, until the G-Codeoption

 

is selected.

3Press the button to select G-Code.

Result: A message is displayed to allow you to enter the G-Code code.

If all six programmes have been set, the message Timer is Full is displayed. Refer to page 38 if you wish to cancel a preset recording.

4Press the numeric buttons to enter the code opposite the pro gramme that you wish to record in your television magazine.

If you wish to correct the G-Code code that you are entering:

Press the button until the digit to be corrected is cleared

Enter the correct digit

5Press the OK button.

Result: The information concerning the programme is displayed.

When using the G-Code function for the first time with stored stations, the programme number flashes. This one time, you must enter the station number manually by

pressing the

or

buttons. Refer to the following page if:

The programme number or times flash

You wish to modify the programme

6If the programme and times are correct, press the RETURN button.

7Press the STANDBY/ON button to activate the timer.

8Refer to page 38 if you wish to:

Check that your VCR has been programmed correctly

Cancel a preset recording

The numbers next to each TV programme listing are G-CODE code numbers, which allow you to programme your videorecorder instantly with the remote control. Tap in the G-CODE code for the programme you wish to record.

G-CODE is a trademark of Gemstar Development Corporation. The G-CODE system is manufactured under licence from Gemstar Development Corporation.

OK

1

Timer Method

Standard

G-Code

(DVD-V70)

Timer Method

If you want to set the timer program,

press the key.

G-Code

Code

Code

: 0 - 9

Correct

:

STANDBY/ON

OPEN/CLOSE

7

GB

35

Page 35
Image 35
Samsung Using the G-CODE Feature DVD-V80/ DVD-V85 Only, Press the Timer button Result The Timer Method is displayed