Automatic charging
Recharging |
When the battery indicator blinks during cleaning, POWERbot will return to the charger to charge itself automatically.
You may command POWERbot to recharge at the charger while it is in cleaning process.
Low battery (Lo)
Manually charge POWERbot by placing it on the charger.
Steps to take if recharging is not being executed
Check the installation status of the charger when:
▶▶charger is located in a place where POWERbot cannot easily access
▶▶distance of the charger and POWERbot is over 5 m apart
Manually charge POWERbot when:
▶▶charger is located in a corner ▶▶battery is fully exhausted
▶▶POWERbot is stuck by obstacles (furniture etc.)
▶▶POWERbot can't climb threshold near charger (Height of the threshold that POWERbot can climb: about 1.5 cm and below)
▶▶when battery indicator blinks and "Lo" is displayed
▶▶when POWERbot is set on Spot clean or Manual clean mode
