Samsung WA484DSHAWR, WA484DSHASU Basic Location Requirements, Electrical, Grounding, Water

installing your washer

BASIC LOCATION REQUIREMENTS

Electrical

•120 Volt 60 Hz 15 AMP fuse or circuit breaker

•Individual branch circuit serving only your Washer is recommended.

•Your Washer is equipped with a power cord.

NEVER USE AN EXTENSION CORD.

CAUTION

Grounding

ELECTRICAL GROUNDING IS REQUIRED FOR THIS APPLIANCE.

This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current.

This appliance is equipped with a power cord having a three-prong grounding plug for use in a properly installed and grounded outlet.

The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Improper connection of the equipment-grounding conductor can result in a risk of electrical WARNING shock. Check with a qualifi ed electrician or serviceman if you are in doubt as to whether the

appliance is properly grounded. Do not modify the plug provided with the appliance – if it does not fi t the outlet, have a proper outlet installed by a qualifi ed electrician.

IMPORTANT SAFETY PRECAUTIONS

•To prevent unnecessary risk of fi re, electrical shock or personal injury, all wiring and grounding must be done in accordance with the National Electrical Code ANSI/FNPA, No. 70 Latest Revision and local codes and ordinances. It is the personal responsibility of the appliance owner to provide adequate electrical service for this appliance.

NEVER CONNECT THE GROUND WIRE TO PLASTIC PLUMBING LINES, GAS LINES, OR CAUTION HOT WATER PIPES.

Water

To correctly fi ll your Washer in the proper amount of time, water pressure of 20 to 116psi (137 to 800kPa) is required.

Water pressure less than 20 psi may cause water valve failure, or may not allow the water valve to shut off completely, or may extend the fi ll time beyond what your Washer controls allow, causing your Washer to turn off. A time limit is built into the controls to prevent fl ooding in your home if a hose becomes loose.

The water faucets must be within 4 feet / 122 cm of the back of your Washer to match the inlet hoses provided with your Washer.

Accessory inlet hoses are available in various lengths up to 10 feet / 305 cm for faucets that are further away from the back of your Washer.

To avoid the possibility of water damage:

•Have water faucets easily accessible

•Turn off faucets when the washer is not in use.

•Periodically check that there is no leakage from the water inlet hose fi ttings.

CHECK ALL CONNECTIONS AT THE WATER VALVE AND FAUCET FOR LEAKS.

WARNING

12_ installing your washer

WA484DSHA-03050D_EN.indd Sec3:12

2012-07-02 ￿￿ 3:39:18